Chapter 6: Operation
Chapter 6: Operation
Silencing Alarms
Silencing Alarms
Page 6-16
Page
6-16
Table 6-1: Printout Legend (Continued)
Table 6-1: Printout Legend (Continued)
15
15
rh
rh
15.4 || || 15.33
15.4
15.33 || || 15.43
16
16
Alarm: Pump
Alarm: Pump
17
17
18
18
Alarm: Laser
Alarm: Laser
Stat
Statistics Mode Sample
istics Mode Sample Print
When the LASAIR II is operated in statistics mode, sample printouts have the
When the LASAIR II is operated in statistics mode, sample printouts have the
room name appended to the sample strip. The room is printed directly above
room name appended to
location name.
location name.
If the alarm is activated, the
If the alarm is activated, the Main Display Screen
Screen
Screen) will blink red and yellow. If the audio alarm has been set, the unit will
) will blink red and yellow. If the audio alarm has been set, the unit will
beep.
beep.
To silence an alarm:
To silence an alarm:
Press the
Press the Enter
Enter key or one of
key or one of the arrow buttons on the control pan
alarms are off. The value in alarm will remain in
alarms are off. The value in alarm will remain in red on the
if it is a particle count value (or on the
if it is a particle count value (or on the Analog Data Display Screen
analog value).
analog value).
To stop the red and yellow flashing:
To stop the red and yellow flashing:
After the pump stops, press the Enter key once more after pressing it to silence
After the pump stops, press the Enter key once more after pressing it to silence
the alarm. Y
the alarm. You can also silence
ou can also silence alarms and stop the red and yellow
repeating the sampling, without exceeding an alarm limit, or by turning the
repeating the sampling, without exceeding
OFF and then ON.
OFF and then ON.
LASAIR II II Operator's
LASAIR
PCT
PCT
rh: relative humidity PCT: percent
rh: relative humidity PCT: percent
15.43
A A verage ||
verage || minimum || and
humidity in percent. (See lines 12 and 14.)
humidity in percent. (See lines 12 and 14.)
This line prints when the LASAIR II senses
This line prints when the LASAIR II senses
that the flow rate is outside the boundary of 1
that the flow rate is
CFM ±5%. (Also see line 3b.)
CFM ±5%. (Also see line 3b.)
This line prints when the LASAIR II senses
This line prints when the LASAIR II senses
that the laser power is out of the specified
that the laser power is out of
range. (Also see line 3b.)
range. (Also see line 3b.)
Print
the sample strip. The room is printed directly above the
Main Display Screen (and
the arrow buttons on the control panel until all
red on the Main
Analog Data Display Screen, if it is an
alarms and stop the red and yellow blinking by
an alarm limit, or by turning the unit
Operator's Manual
Manual
minimum || and maximum relative
maximum relative
outside the boundary of 1
the specified
(and Analog Data Display
Analog Data Display
el until all
Main Display
Display Screen
Screen
, if it is an
blinking by
the
unit