GRAPHTEC CE6000-120AP Setup Manual page 6

3
Set the stock shaft in from the front.
Align the receiving end of the media shaft with the grooves on the roller and push
down firmly to set it in place.
Stock shaft
Lever
Please make sure to set in the direction of the paper.
4
The left and right media flanges feed in the paper roll media. Please tighten the
flange screw and fasten the paper roll into the desired position.
5
Lower the media set lever to raise the push rollers.
Groove
Roller
Push roller
Media set lever
CAUTION
•
During a plotting or cutting operation, be
sure to keep your hands, hair, and so forth
away from the media stocker, gears and
rollers.
•
When you are installing media, be careful for
gear, a roller, etc. not pinch you finger.
•
Deviations and errors may result if the stock
shaft is misaligned when plotting begins.