GRAPHTEC CE6000-120AP Setup Manual page 4

3
Make sure that the tool bracket is engaged on the tool's flange, and then tighten the screw.
Removing the tool
When removing the tool, turn it counterclockwise to remove the tool.
Attaching a pen
Attach a pen to the pen station.
•
Please make sure to attach the pen to the pen station when setting up a pen.
•
To prevent injury, avoid touching the pen immediately after the cutting plotter is turned on or whenever the pen is moving.
1
You can attach the pen by opening up the holder on the pen station with your finger.
2
. Once the pen is attached, releasing the holder fixes the pen in place.
Removing a pen
You can remove the pen by lifting up the holder.
Bracket to hold tool
Holder
Always fit into grooves on the pen.
Flange

Supplement
Make sure to check that the top part of any
tools mounted on the pen station is set in the
grooves above the pen.