GRAPHTEC CE6000-120AP Setup Manual page 7

6
Put the roll media on the roll media tray and then push the tip of the roll media
forward from the back of the machine. Make sure to pull it so that there is no
slackening across the roll media's route.
The paper roll media's route goes over the center bar and behind the media
guide bar.
Media guide bar
7
Position the media and the push rollers to correspond with the width of the media.
Use the 5 push rollers to push down the sides and center of the media.
Use the grit roller position guide and make sure the push rollers are on top of the
grit rollers.
You can adjust the center push roller's hold-down force.
Push roller
Grit roller position guide
Push roller
Grit roller
Media sensor
(The push roller is on top of the grit roller.)
(The center push roller is near the edge.)
When Feeding Long-axis Media (at exceeds 2 meters)
Position the push rollers at least 15 mm inside the edges of the media.
Push roller
15mm
Media
Media guide
Media sensor
(The push roller is on top of the grit roller.)
(The center push roller is near the
15mm
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers"
about the position of the push rollers.
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers"
about the position of the push rollers.
•
See "Aligning the Push Rollers"
information about center 3 push roller hold-
down force.
edge.)
When setting on inside more than 30 mm, cut
cross is not available.

CAUTION
P.09
P.09
for
P.09