GRAPHTEC CE6000-120AP Setup Manual page 11

3
Press the [ENTER] key.
After the DISPLAY LANGUAGE is selected, the LENGTH UNIT screen will appear.
4
Press the [1] key (METRIC) or the [2] key (INCH) to select the length unit setting.
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and the default screen is displayed.
5. Set the media type into the Plotter.
Set the media type into the Plotter depending on the preset media.
1
If you have already loaded the media, the MEDIA TYPE menu appears.
Select the media type to suit the loaded media.
Plot starting with the edge of media.
Roll media
Plot starting with the preset position.
Sheet media Set a sheet media.
CONTINUE When similar media is reset
2
After the media is detected, the plotter is ready to receive data for cutting or
plotting. This status is called "READY status" of the default screen.
When setting is finished, the tool carriage's location will become the initial point.
Default screen is displayed.
* The default value for the command setting is HP-GL, and the origin position is lower left.
6. Tool adjustment and test cutting
Adjust the Blade Length
Optimal cut is not achieved unless the blade length is adjusted in accordance to the used media and the cutter blade.
Perform further adjustment by performing cutting test after adjusting the blade length manually.
CAUTION
•
To avoid bodily injury, handle cutter blades with care.
•
It may result to damaging the cutter blade or the cutting groove if the blade is extended too much.
Supplement
See "Running Cutting Tests"
[1] ROLL-1 FRONT EDGE
[2] ROLL-2 CURRENT POSITION
[3] SHEET
[4] CONTINUE
or cutting tests.
P.12
Release the stopper lock.
Supplement
The CONTINUE menu parameter appears
when the media set lever is raised and then
lowered again after media was previously
loaded, making it possible to select the
previous settings.
Simple menu/Normal menu
You can use the [SIMPLE] key on the default
screen to switch between Simple menu and
Normal menu.
In Simple menu you can change easy settings
from the menu screen.
In Normal menu, you will be able to change
more detailed settings.
For details, see "About Simple menu"
P.2-43
11
CAUTION
.