Operate Screen: Ready To Run - Omron Microscan LVS 7000 Operation Manual

Operate Screen: Ready to Run

Each button on the Operate Screen (Ready to Run) is described in the table below.
Button
Delete This Job
View Logs
Edit Job
Exit to Main
Make Ready
Continue Last Run
Start New Run
LVS-7000 Operations Manual Version 5.6.X
Click to delete the job. Only operators who are granted the Allow Create NEW
Job permission is allowed to delete a job. Refer to the Permissions section,
within the Operators section, for more information on permissions.
A Report Log is created for every job. Click this button to view all previous
Reports. (See the Reports chapter for more information on reports.)
Click to change the current job settings. If a password was used, you must enter
the correct password for the job. Only operators who are granted the Allow
Create NEW Job permission is allowed to edit a job. Refer to the Permissions
section, within the Operators section, for more information on permissions.
Click to change to a previously set up job; this will bring you back to the
Welcome Screen where you may select Load a Job.
Make Ready operates exactly as if the system were running normally with the
exception that no data is stored and no I/O is triggered. See the section below
titled "Make Ready Mode" for more information.
Select this option if you desire to append to the most recent run's CSV file.
Click to begin a new run and new CSV file.
LVS-7000 Operations Manual Version 5.6.X
Description
Page 85 of 187