Omron Microscan LVS 7000 Operation Manual page 151

Table of Contents

Advertisement

4. Save changes and close the Lvs7000.ini file.
5. Open the LVS-7000 program.
6. Click OK at the Image Saver warning (see below).
7. Click the Create a New Job button and stay at the Label Repeat screen.
8. Run the printer to obtain a desired amount of images. The system is capturing images although the on-
screen images may not immediately update.
9. Stop the Job and close the software; then, stop the printer.
10. Navigate to the Image Capturing folder that was created earlier and the images should appear from the last
job.
11. When image capturing is complete, go to the Lvs7000.ini file, remove the Path and leave SaveLabelRepeat
at 0 (see below).
12. If you were using the Strobe feature, then scroll down to the [System] section and switch Strobe=0 back to its
original setting.
13. Remember to remove all excess images as they quickly take up space on the Hard Drive.
LVS-7000 Operations Manual Version 5.6.X
LVS-7000 Operations Manual Version 5.6.X
Page 151 of 187

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LVS 7000 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents