Introduction - Omron Microscan LVS 7000 Operation Manual

Table of Contents

Advertisement

Introduction

The LVS-7000 is a vision-based system designed to inspect print quality at line speeds for the following areas:
The camera type (color or monochrome) required by each module is noted below.
1D Barcode Verification (ISO/IEC Standards) – may be used with a monochrome or color camera. If
barcodes are printed in any color scheme other than black and white, the "Barcode Health Check" module
must be used.
2D Barcode Verification (ISO/IEC Standards) – may be used with a monochrome or color camera
Barcode Validation (Read Only) (1D and 2D) – may be used with a monochrome or color camera
Blemish Detection – may be used with a monochrome or color camera
Optical Character Verification – may be used with a monochrome or color camera
Optical Character Recognition – may be used with a monochrome or color camera
Barcode Health Check – may be used with a monochrome or color camera
Delta E – typically used with a color camera
The LVS-7000 is a modular system, which means that you can check the print quality for any of the
aforementioned areas, or for all of the areas depending on which software modules were purchased. Below is a
list of the available software modules:
The software modules listed below can be purchased at any time. Contact your Omron Microscan
representative or Omron Microscan headquarters at +1-800-762-1149 or helpdesk@microscan.com for further
details. After purchasing a module, refer to "Appendix D: Activating Modules" for activation steps.
LVS-7000 Operations Manual Version 5.6.X
LVS-7000 Operations Manual Version 5.6.X
Page 5 of 187

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LVS 7000 and is the answer not in the manual?

Table of Contents