Table of Contents
Advertisement
2
General information
The regulator ecoMAX920P1-K TOUCH is a
device designed to control the operation of a
boiler with automatic feeding of solid fuel
with a igniter. Flame detection is performed
with the use of an optical flame brightness
sensor. It can control the work of central
heating and hot water circuits and also
control the work of 5 mixing heating circuits.
The required temperature of heating circuits
can be set on the basis of data obtained from
the
main
sensor.
cooperation with room thermostats, separate
for each heating circuit is beneficial for
maintaining
comfortable
heating rooms. Moreover, the device turns
on the spare boiler (-gas or –oil). The
regulator may operate in connection with
additional
wire
ecoSTER200, ecoSTER TOUCH and wireless
room
thermostat/panel
eSTER_x40
installed
ecoNET300 Internet module. Additionally it
cooperates with ecoLAMBDA module and
extension B and C modules.
The regulator may be used in households
and other similar premises and in light
industry facilities.
3
Information about documentation
The regulator manual is a supplement for the
boiler manual. In particular, except for this
manual, the boiler manual should also be
observed. The regulator manual is divided
into two parts: for user and fitter. Yet, both
parts
contain
important
significant for safety issues, hence the user
should read both parts of the manual.
We are not responsible for any damages
caused
by
failure
instructions.
4
Storage of documentation
This assembly and operation manual, as well
as
any
other
applicable
should be stored diligently, so that it was
available at any time. In the case of removal
or
sale
of
the
documentation should be handed over to the
new user / owner.
The
possibility
temperature
room
thermostat/panel
eSTER_x80
in
rooms
information,
to
observe
these
documentation,
device,
the
attached
5
Applied symbols
In this manual the following graphic symbols
are used:
- useful information and tips,
- important information, failure to
observe these can cause damage of
property,
household animal health and life.
Caution: the symbols indicate important
information, in order to make the manual
of
more lucid. Yet, this does not exempt the
user from the obligation to comply with
requirements which are not marked with a
in
graphic symbol!
6
Directive WEEE 2012/19/UE
Purchased product is designed and made of
materials of highest quality.
The product meets the requirements of the
Directive 2012/19/EU of 4 July 2012 on
or
waste
and
equipment (WEEE), according to which it is
marked
wheeled bin (like below), meaning that
product is subjected to separate collection.
Responsibilities after finishing a period of
using product:
dispose of the packaging and product at
the end of their period of use in an
appropriate recycling facility,
do not dispose of the product with other
unsorted waste,
do not burn the product.
By adhering obligations of waste electrical
and electronic equipment controlled disposal
mentioned above, you avoid harmful.
5
threat
for
electrical
and
by
the
symbol
of
human
and
electronic
crossed-out
Hide quick links:
Advertisement
Table of Contents
