Table of Contents
Advertisement
2
General information
The controller ecoMAX920P1-S TOUCH is
designed to control the operation of a solid
fuel boiler using an optical flame brightness
sensor.
The
controller
operation of direct central heating circuit,
HUW circuit and operation of five mixing
heating circuits. The preset temperature of
circuits can be set on the basis of weather
sensor
indications.
cooperation with room thermostats, separate
for each heating circuit is beneficial for
maintaining
comfortable
heating rooms. Moreover, the device turns
on the auxiliary gas or oil boiler if necessary.
The controller may operate with additional
room panel or room thermostat placed in a
living room and λ probe module, additional
expansion modules B, C and internet module
ecoNET300 to operate the controller on-line.
The controller may be used in households
and other similar premises and in light
industry facilities.
3
Information about documentation
The controller's manual is a supplement for
the boiler manual. In particular, except for
this manual, the boiler manual should also be
observed. The controller's manual is divided
into two parts: for user and fitter. Yet, both
parts
contain
important
significant for safety issues, hence the user
should read both parts of the manual.
We are not responsible for any damages
caused
by
failure
instructions.
4
Storage of documentation
This assembly and operation manual, as well
as
any
other
applicable
should be stored diligently, so that it was
available at any time. In the case of removal
or
sale
of
the
documentation should be handed over to the
new user / owner.
5
Applied symbols
In this manual the following graphic symbols
are used:
- useful information and tips,
can
control
The
possibility
temperature
information,
to
observe
these
documentation,
device,
the
attached
- important information, failure to
observe these can cause damage of
property,
household animal health and life,
the
Caution: the symbols indicate important
information, in order to make the manual
more lucid. Yet, this does not exempt the
user from the obligation to comply with
of
requirements which are not marked with a
graphic symbol!
6
Directive WEEE 2012/19/EU
in
Purchased product is designed and made of
materials of highest quality.
The product meets the requirements of the
Directive 2012/19/EU of 4 July 2012 on
waste
equipment (WEEE), according to which it is
marked
by
wheeled bin (like below), meaning that
product is subjected to separate collection.
Responsibilities after finishing a period of
using product:
dispose of the packaging and product at
the end of their period of use in an
appropriate recycling facility,
do not dispose of the product with other
unsorted waste,
do not burn the product.
By adhering obligations of waste electrical
and electronic equipment controlled disposal
mentioned above, you avoid harmful effects
on the natural environment and risks to
human health.
5
threat
for
electrical
and
the
symbol
of
human
and
electronic
crossed-out
Advertisement
Table of Contents
