Table of Contents
Advertisement
2
General information
The controller ecoMAX860P3-KL is a device
designed to control the operation of a boiler
with automatic feeding of solid fuel with a
igniter. Flame detection is performed with
the use of an optical flame brightness sensor.
It can control the work of central heating and
hot water circuits and also control the work
of 5 mixing
heating circuits. The required
temperature of heating circuits can be set on
the basis of data obtained from the main
sensor. The possibility of cooperation with
room thermostats, separate for each heating
circuit
is
beneficial
comfortable temperature in heating rooms.
Moreover, the device turns on the spare
boiler (-gas or –oil). The controller may
operate in connection with
ecoSTER
TOUCH
installed in rooms and ecoNET300 Internet
module.
Additionally
ecoLAMBDA module and extension modules B
and C.
The controller may be used in households
and other similar premises and in light
industry facilities.
3
Information about documentation
The controller manual is a supplement for
the boiler manual. In particular, except for
this manual, the boiler manual should also be
observed. The controller manual is divided
into two parts: for user and fitter. Yet, both
parts
contain
important
significant for safety issues, hence the user
should read both parts of the manual.
We are not responsible for any damages
caused
by
failure
instructions.
4
Storage of documentation
This assembly and operation manual, as well
as
any
other
applicable
should be stored diligently, so that it was
available at any time. In the case of removal
or
sale
of
the
documentation should be handed over to the
new user / owner.
for
maintaining
ecoSTER200,
additional
room
panel
it
cooperates
information,
to
observe
these
documentation,
device,
the
attached
5
Applied symbols
In this manual the following graphic symbols
are used:
- useful information and tips,
- important information, failure to
observe these can cause damage of
property,
household animal health and life.
Caution: the symbols indicate important
information, in order to make the manual
more lucid. Yet, this does not exempt the
user from the obligation to comply with
requirements which are not marked with a
graphic symbol!
6
Directive WEEE 2012/19/UE
Purchased product is designed and made of
materials of highest quality.
The product meets the requirements of the
Directive 2012/19/EU of 4 July 2012 on
with
waste
equipment (WEEE), according to which it is
marked
wheeled bin (like below), meaning that
product is subjected to separate collection.
Responsibilities after finishing a period of
using product:
dispose of the packaging and product at
the end of their period of use in an
appropriate recycling facility,
do not dispose of the product with other
unsorted waste,
do not burn the product.
By adhering obligations of waste electrical
and electronic equipment controlled disposal
mentioned above, you avoid harmful.
5
threat
for
electrical
and
by
the
symbol
of
human
and
electronic
crossed-out
Advertisement
Table of Contents
