Maintenance Safety Guidelines - KEB COMBISTOP Instruction Manual

Safety Instructions
CAUTION
Do not start the device until you have confirmed that the installation complies with the
following safety standards.
• Ensure there is sufficient protection against foreign particles entering the air gap. These
particles may impede the motion of the armature.
• Ensure there is sufficient thermal protection such that the brake does not exceed or fall below
the listed temperature limits for the device.
→
Ensure there is protection against accidental contact with rotating or moving parts.
•
Ensure there is sufficient protection from environmental factors such as moisture or
•
aggressive gases that may compromise the integrity of the friction surface or armature.

2.6 Maintenance Safety Guidelines

DANGER
WARNING
CAUTION
Carefully observe the following safety guidelines before performing maintenance on the
brake.
• Ensure the device is powered off and has come to a complete stop before performing any
maintenance.
• Secure the brake so it cannot be switched on accidentally during maintenance.
Disconnect the brake from the load before maintenance to avoid uncontrolled movements.
•
Ensure there is sufficient protection against foreign particles entering the air gap during
•
maintenance.
Ensure there is sufficient protection against moisture or aggressive gasses that may
•
compromise the integrity of the friction surface or armature.
2021 KEB America, Inc.
©
Hot Surfaces!
 The heat generated during the operation of the brake may cause
burns on contact with skin. Always wear appropriate protective
equipment!
See Appendix 1: Technical Specifications for details.
Risk of electrical shock!
 Turn off the power supply and secure it against switching on prior
to any maintenance on the brake.
Moving parts can crush and cut!
 Contact with rotation or moving parts may cause serious injury.
Wait until the drive has come to a complete stop before
performing any maintenance.
 Secure the drive against accidental movement prior to
performing any maintenance.
Hot Surfaces!
 The heat generated during the operation of the brake may cause
burns on contact with skin. Always wear appropriate protective
equipment.
15