Safety Instructions; General Instructions; Transport, Storage And Installation - KEB COMBIVERT R6 Instruction Manual

Safety Instructions

2. Safety Instructions
2.1

General instructions

Electric Shock
Only Qualified
Electro-Perso-
nnel
Observe Stan-
dards
2.2

Transport, Storage and Installation

The storage of the COMBIVERT must be done in the original packing. It is to be protected against humidity and
excessive cooling and thermal effect. A long-distance transport must be carried out in the original packing. It is to
be secured against impact influence. The marking on the final packing must be observed! After removing the final
packing the COMBIVERT must be set down on a stable base.
Protect Against
Accidental
Contact
Hot Surface
6
COMBIVERT R6 power supply und regenerative units contain dangerous voltages which
can cause death or serious injury.
COMBIVERT R6 can be adjusted by way that energy is refeed into the supply system in
case of power failure at generatoric operation. Therefore a dangerous high tension can be in
the unit after switching off the supply system.
Before working with the unit check the isolation from supply by measurements in the
unit.
Care should be taken to ensure correct and safe operation to minimise risk to personnel and
equipment.
All work from the transport, to installation and start-up as well as maintenance may only be
done by qualified personnel (IEC 364 and/or CENELEC HD 384 and IEC-Report 664 and
note national safety regulations). According to this manual qualified staff means those who
are able to recognise and judge the possible dangers based on their technical training and
experience and those with knowledge of the relevant standards and who are familiar with the
field of power transmission.
The COMBIVERT R6 must not be started until it is determined that the installation com-
plies with 2006/42/EC (machine directive) as well as the EMC directive (2004/108/EC) (note
EN60204).
The COMBIVERT R6 meets the requirements of the Low-Voltage Directive 2006/95/EC. The
harmonized standard of the series EN 61800-5-1 (VDE 0160) is used.
This is a product of limited availability in accordance with IEC 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take
corresponding measures.
The COMBIVERT R6 must be protected against invalid loading. Components and covers
must not be bent or moved as this may affect insulation distances. The units contain electro-
static sensitive devices which can be destroyed by inappropriate handling. For that reason
the contact of electronic devices and contacts is to be avoided. The equipment must not be
switched on if it is damaged as it may no longer comply with mandatory standards.
Make sure that during installation there is enough minimum clearance and enough cooling.
Climatic conditions must be observed in accordance with the instruction manual.
Heat sinks can reach temperatures, which can cause burns when touching. If in case of
structural measures a direct contact cannot be avoided, a warning notice "hot surface" must
be mounted at the machine.