Figure 5 Mounting The Hub; Figure 6 Gap Between Hub And Friction Surface - KEB COMBISTOP Instruction Manual

Installation
4. Secure the hub to the drive shaft axially, using set screws, retaining ring, or another
method required by the specified application.

Figure 5 Mounting the Hub

5. Carefully slide the friction lining (3) onto the hub splines or fingers (2). The friction lining
must be free to move axially on the hub.
6. Slide the magnet system (1) onto the shaft until the hollow spacers contact the
flange/friction surface as shown below.
2021 KEB America, Inc.
©
i
 Ensure the hub cannot run against the friction surface!
 KEB America, Inc. recommends leaving a space of 0.5mm to
1mm between hub and friction surface to prevent friction and
wear and tear on the hub.
→ See Figure 7 Air Gap for details.
Figure 6 Gap between Hub and Friction
Surface
25