Replacing The M.2 Mass Storage Device Attached To The M.2 Connector - Matrox 4Sight EV6 Installation And Hardware Reference

Important

Replacing the M.2 mass storage device attached to the M.2 connector

Replacing the M.2 mass storage device
attached to the M.2 connector
An M.2 mass storage device comes pre-installed in your Matrox 4Sight EV6 unit's
M.2 connector. This mass storage device comes pre-loaded with your software and
licensing. You should make a backup of this mass storage device before replacing it.
To replace the M.2 mass storage device in the Matrox 4Sight EV6 unit, perform
the following:
1. Unplug the power supply from your unit.
2. Remove the chassis cover. To see instructions on how to do so, refer to Removing
the Matrox 4Sight EV6 chassis cover section, earlier in this chapter.
3. Remove the screw that holds the M.2 mass storage device to the motherboard.
The board will spring up at a 20 degree angle. Pull the board out at the same angle.
4. Slip the edge of the new M.2 mass storage device into the connector from which
you removed the previous mass storage device. The connecting edge will fit neatly
into the socket, leaving the board at a 20 degree angle from the motherboard.
Caution
Be sure to turn off the power to
the unit and all peripherals as
well as unplug the power from
the unit before adding or
removing devices.
connector
mini board
20°
57