Matrox 4Sight EV6 Installation And Hardware Reference page 13

Matrox Capture
Assistant
Matrox Capture
Works
Matrox Capture Assistant is a utility that allows you to rapidly test and evaluate
the performance of virtually any GenICam-compliant device using MIL. GigE
Vision and USB3 Vision devices are currently supported. It can also be used to
configure Host controller settings (such as network adapters) and Matrox-specific
configuration.
Matrox Capture Works is a utility that allows you to rapidly evaluate the
performance and functionality of virtually any GigE Vision-compliant camera or
3D sensor (or other device). Matrox Capture Works will list all detected GigE
Vision-compliant devices connected to your computer. It can start or stop
capturing images, display acquired images, save the last grabbed image, send a
software trigger, as well as browse and control the selected device's features. You
can view network adapter information (such as, the IP address, packet size,
inter-packet delay), view and change device information (such as, the user-defined
name of your device), view and change acquisition properties, and view acquisition
statistics. You can use it to configure the device and network adapter in static IP
mode (or point-to-point connection mode) or DHCP mode (or corporate
network mode). Matrox Capture Works uses the Matrox GigE Vision discovery
service to automatically detect when GigE Vision-compliant devices are added to
or removed from your network. Matrox Capture Works is distributed with MIL
and Matrox Design Assistant; it is also available with MIL-Lite.
Matrox Imaging software 13