Matrox 4Sight EV6 Installation And Hardware Reference page 25

Warning
3. Apply the tip of your soldering iron to each wire for a second; then, apply solder
to the wire. The solder should flow freely onto the wire and coat it. Clean off any
excess solder, if necessary.
4. Connect the exposed ends of your power supply cable into the power connector
latch. To do so, push the red wire into the positive (+) wire-terminal slot and the
black wire into the negative (-) wire-terminal slot.
wire-terminal (
)
To ensure EMC conformity, you must connect the chassis ground wire-terminal
of your Matrox 4Sight EV6 unit to earth ground.
5. Secure the wires into their wire-terminal slots by tightening the screw associated
with the wire, at the bottom of the power connector latch.
Connection to
earth-ground
6. Return to the Operating your Matrox 4Sight EV6 for the first time section for
instruction on how to connect the power connector latch to the power connector
of your unit.
1. Be aware that some power supplies might have different colors, verify the
polarity of your wires before attaching them.
Making your own open-wire power supply cable
to earth ground.
Power connector latch
-
+
Bottom
Power
supply
cable
1
Connect the chassis ground
- +
Bottom
Screws to tighten
the wires in-place
25
o