Os Backup Of Matrox 4Sight Ev6 Windows 10 Iot Enterprise - Matrox 4Sight EV6 Installation And Hardware Reference

OS backup of Matrox 4Sight EV6 Windows 10
IoT Enterprise
You can create an OS backup .wim file of your Matrox 4Sight EV6 unit's operating
system partition and save the file to a specified location. It is useful to do this
procedure if you need to save any changes made to the specific Matrox 4Sight EV6
unit. Note that the OS backup process will copy the unique ID of the unit. This
ID will be applied to any Matrox 4Sight EV6 that is restored with this backup
.wim file; therefore, an OS backup should only be applied to the same unit from
which it was taken. If two units with the same unique ID are running on the same
network, there will be network conflicts. Be aware of this limitation when
performing an OS backup.
To perform an OS backup, you must access your Matrox 4Sight EV6 directly; you
cannot perform this task remotely. To access the unit directly, connect a display
device, keyboard, and mouse to your Matrox 4Sight EV6. For information, refer
to Connecting peripheral devices subsection of the Connecting peripheral devices
section, in Chapter 2: Getting started with your Matrox 4Sight EV6 unit for more
information.
To backup your operating system partition, perform the following directly from
your Matrox 4Sight EV6:
1. Save all your work and close all running applications.
2. From the Windows Start menu, launch the OSConfig utility.
3. Go to the Write Filter tab. If the Unified Write Filter (UWF) option is enabled,
disable it.
4. Click on the Capture OS tab.
5. On the Capture OS tab, click on the Reboot and launch backup tool button that
is found in the Backup for this unit area. Your Matrox 4Sight EV6 will reboot.
6. When the reboot process completes, it will display a screen asking you to choose
an option. Click on the Troubleshoot option, and then on the Matrox Rescue
Utility option.

OS backup of Matrox 4Sight EV6 Windows 10 IoT Enterprise

91