Drive Assignments - Matrox 4Sight EV6 Installation And Hardware Reference

56 Chapter 3: Adding devices to Matrox 4Sight EV6
7. Tighten the 4 screws that hold the bottom mass storage device to the brackets. If
you are installing a second mass storage device, also tighten the 4 screws that hold
the top mass storage device to the brackets.
8. Each SATA mass storage device has connectors to attach 2 cables: a 7-pin cable
for data and a power cable. These must be connected to the appropriate connectors
on the motherboard.
Note that, the cables fit best if they are coiled slightly before the base plate is

lowered down on to the chassis.

Drive assignments

When you connect a mass storage device to a 7-pin SATA connector, the operating
system and UEFI identify it by the SATA connector (port) on the motherboard
to which it is connected. The SATA connector closest to the outer edge of the
motherboard (where the DVI-I and other peripheral ports are found) is port 2
and the other SATA connector is port 3.
You can run the UEFI Setup utility to verify the configuration of your mass storage
devices. Do this by rebooting the Matrox 4Sight EV6 and pressing the Esc key
during power-on self-test (POST). You only have a few moments to press this key
before the boot-up process continues. In the UEFI Setup utility, you can now
make changes to the connected drives, such as selecting a boot order or password
protecting each drive.