General Warnings And Key To Symbols On The Unit; Matrox 4Sight Ev6 Safety Precautions And Key To Symbols - Matrox 4Sight EV6 Installation And Hardware Reference

1
Symbol
o
1. Note that these symbols might not necessarily be the same color as depicted.
2. Manual available on the Matrox Imaging website at http://www.matrox.com/imaging
3. As per CAN/CSA-C22.2 No 61010-1-12, UL std. No 61010-1 (3rd edition), and EN Std. No. 61010-1 (3rd Edition)
General warnings and key to symbols on the
unit
You should be aware of the meaning of the symbols on the unit and important
usage and handling precautions.

Matrox 4Sight EV6 safety precautions and key to symbols

Before installing, connecting to, and using Matrox 4Sight EV6, you shall be aware
of the meaning of the symbols on the unit and important safety precautions.The
following is a list of precautionary symbols on the unit and their meaning:
Description
The case of your Matrox 4Sight EV6 can become quite hot and should not be touched while operating.
Always allow hot surfaces to cool down before touching your Matrox 4Sight EV6.
•Caution: Consult this manual
installation instructions, refer to Chapter 2: Getting started with your Matrox 4Sight EV6 unit and Chapter 3:
Adding devices to Matrox 4Sight EV6; for environmental and electrical specifications and connector pinout
descriptions, refer to Appendix B: Technical information.
This product must be used as specified; otherwise, the protection provided by its components might be
compromised.
•Refer to the Matrox 4Sight EV6 electrical specifications section, in Appendix B: Technical reference for voltages
and current ratings.
•There are no serviceable parts on this product. In case of defect, contact your Matrox representative.
•This product meets the requirements of a Category I installation as per industry standards
•This product is designed for use in a pollution degree 2 environment as per industry standards
•This product is designed for indoor use only.
•This product is designed to operate at temperatures ranging from 0°C to 50°C at a non-condensing relative
humidity of 10 to 90%.
•This product is not intended for use at altitudes exceeding 2000 m.
DC current only.
Matrox 4Sight EV6 can be powered using a power supply between 9 V DC and 27 V DC (0% tolerance).

General warnings and key to symbols on the unit

2
before installing, connecting to, and using Matrox 4Sight EV6. For hardware
17
3
.
3
.