Table of Contents
Advertisement
Required Tools
See below for a list of required tools when performing a VVR installation.
Installation and Calibration
When installing the controls enclosure and calibrating the linkage, the installer will require the following tools:
• #8 x 5/16" screws
• Drill
• 1/4" Hex Driver
• #2 Phillips Screw Driver
When using a VVR with PACE
After installing the VVR, the following tools are required to configure the POT curve for the VVR when using PACE.
• Computer running Windows 7 or higher with Antec Toolbox installed
• Ethernet cable with RJ45 to 4-wire connection
Please see the
POT Curves – PACE
NOTE:
When using a VVR with the FHC
After installing the VVR, the following tools are required to configure the POT curve for the VVR when using an FHC controller.
• Computer running Windows 7 or higher with Field Flash installed (along with any pre-requisite installers)
• BACnet Commissioning Tool (BCT)
• USB-A to USB-B cable (provided when ordering the BCT)
• Ethernet cable with RJ45 (type B) to 3-wire connection
NOTE:
Please see the
POT Curves – FHC
When using a VVR with the LMX
After installing the VVR, the following tools are required to configure the POT curve for the VVR when using an LMX.
• Computer running Windows 7 or higher with Field Flash installed (along with any pre-requisite installers)
• Linker2 Tool
• USB-A to USB-B cable (provided when ordering the Linker2)
• RJ12 Cable
NOTE:
Please see the
POT Curves – LMX
7 | VVR– Manual | AntecControls.com
• Controls screwdriver
• Wire Cutters
• Wire Strippers
• 7/16" Wrench (x2)
• 1/2" Wrench
section of the manual for connection instructions.
section of the manual for connection instructions.
section of the manual for connection instructions.
VVR - MANUAL
Advertisement
Table of Contents
