Potentiometer Curves; Configuring A Pot Curve For Pace - Prince Antec Controls Retrofit Manual

POTENTIOMETER CURVES

Potentiometer (POT) curves are required any time a VVR is installed on an existing venturi valve in the field. If provided by the
original manufacturer or the building owner, this curve can be configured by the factory prior to shipping the VVR.
If the POT curve has been configured by the factory, please skip to the
If the POT curve has not been configured by the factory, please see below for instructions to configure a POT curve onto a VVR
when using either the PACE,

Configuring a POT Curve for PACE

22 | VVR– Manual | AntecControls.com
FHC or the LMX.
STEP 1
Ensure the unit is powered and has a BLUE light.
NOTE:
STEP 2
Connect a computer to PACE by using either the Keystone Jack (CKJ) or by connecting
directly to PACE.
NOTE:
manual.
STEP 3
Open Antec Toolbox while connected to PACE.
Calibration Section
Please see the PACE Manual for power requirements
For more information on connecting to PACE please refer to the Toolbox
VVR - MANUAL
of this manual.
CAUTION
If applying temporary power to configure
the POT curve and none of the other
controllers on RIN are powered. Ensure
to remove the room configuration after
completing the POT curve configuration.