Table of Contents
Advertisement
Configuring a POT Curve for LMX
29 | VVR– Manual | AntecControls.com
STEP 1
Ensure the unit has power.
NOTE:
Please see the LMX Product Submittal for power requirements
STEP 2
Connect the RJ12 cable to the SERVICE port on the LMX.
STEP 3
Connect the Linker2 to the laptop using the USB-A to USB-B cable.
STEP 4
Open the Field Flash program.
STEP 5
The program will automatically detect a COM port that is communicating with the
LMX. If a COM port is not automatically detected, use the Scan COMs button to scan
again. If connection is still not detected, please proceed to the
of the manual.
VVR - MANUAL
CAUTION
If experiencing connection issue to the
FHC, unplug any unneeded USB devices
and disconnect any Bluetooth devices
from the computer before starting the
program.
Troubleshooting
section
Advertisement
Table of Contents
