Table of Contents
Advertisement
Mounting Instructions for a Single Valve
2.25
9 | VVR– Manual | AntecControls.com
2.25
STEP 1
Make a mark 2.25" from the middle of the control arm shaft.
STEP 2
Align the groove so that it's in-line with the pressure tap. Ensure that the bracket is lined up
with the 2.25" mark and is still parallel to the main base plate.
NOTE:
Ensure the mounting bracket isn't sitting on top of any hardware.
STEP 3
Ensure the edge of the actuator mounting bracket is parallel with the edge of the base plate.
Marked by the orange lines in the figure.
VVR - MANUAL
Advertisement
Table of Contents
