Table of Contents
Advertisement
12 | VVR– Manual | AntecControls.com
STEP 8
To mount the FHC, use the mounting bracket and install 4 self-tapping screws.
To mount the FHC in the correct location please ensure the following:
1.
The controller leaves enough room for the pressure tubing to be connected.
2.
There is sufficient space for the 3-pole terminal block to be mounted and wired in.
NOTE:
Self-tapping screws are not provided with the VVR. The recommended size is a 3/8"
self-tapping screw for metal.
STEP 9
To mount the LMX, use the mounting bracket and install 4 self-tapping screws.
To mount the LMX in the correct location pleasure ensure the following:
1.
The controller leaves enough room for the pressure tubing to be connected.
2.
There is sufficient space for the 3-pole terminal block to be mounted and wired in.
Self-tapping screws are not provided with the VVR. The recommended size is a 3/8"
NOTE:
self-tapping screw for metal.
STEP 10
Mount the 3-pole terminal block on the left hand side of the enclosure. The terminal block
should be mounted on the oppposite side of the pressure tubing. The terminal block can be
fastened to the enclosure with two 3/8" self-tapping screws for metal.
VVR - MANUAL
Advertisement
Table of Contents
