Prince Antec Controls Retrofit Manual page 5

4 | VVR– Manual | AntecControls.com
FHC (Single Valve)
The single venturi valve retrofit for the FHC ships with several different components. The
components are outlined in this section for a single venturi valve with an FHC.
Component Quantity
FHC 1
FHC Mounting 1
Bracket
Potentiometer 1
Cable
Green Pressure 1
Tubing
Red Pressure 1
Tubing
Terminal Block 1
Actuator 1
Mounting Bracket 1
with Linkages
NOTE: Unit is shipped with label on the bottom of the FHC to indicate which valve it should
be installed on. The image on the left hand side shows the bottom of a FHC with the
corresponding identification label.
VVR - MANUAL
Description
Single FHC controller.
Bracket used to mount the FHC to the controls
enclosure.
Cable used to connect the FHC to the
potentiometer.
The low-pressure tubing comes with a length of
tubing and a connector tee.
The high-pressure tubing comes with a length of
tubing and a connector tee.
3-pole terminal block that will be used to wire the
potentiometer cable to the existing potentiometer
The actuator comes mounted on the mounting
bracket and shaft.
The single venturi valve mounting bracket and
linkages comes pre-assembled. The unit just needs
to be positioned and fastened with 4 self-tapping
screws.
CAUTION
When units are shipped mounted in an
enclosure, the label will be shown on the
enclosure.