Table of Contents
Advertisement
POTENTIOMETER REPLACEMENT
In some cases, it may be appropriate to change the potentiometer on the valve.
Potentiometer Replacement (Option #1)
35 | VVR– Manual | AntecControls.com
STEP 1
Loosen the shaft coupler by loosening the 2 hex screws. Slide the Shaft Coupler onto
the rotating pin. Twist the potentiometer plate tabs until aligned with the base plate
mounting slots.
STEP 2
Slide the potentiometer plate down through the mounting slots, slide back and lift up
through the large slotted opening.
Discard the old potentiometer and shaft collar.
NOTE:
Using the new potentiometer replacement slide the potentiometer plate down through
the large slotted opening in the base plate, slide forward and lift up through the
mounting slots.
STEP 3
Twist the replacement potentiometer plate tabs until they're approximately twisted 30-
45 degrees. This will fix the potentiometer plate in place.
NOTE:
Do not exceed a 60-degree twist.
VVR - MANUAL
Advertisement
Table of Contents
