Table of Contents
Advertisement
INTRODUCTION
General
In this manual, you will find information regarding:
• Venturi Valve Retrofit (VVR) specifications
• How to install the VVR with the Pace
(PACE), the Fume Hood Controller (FHC) and the Linear Module
(LMX)
• Detailed description of all options available for each setup and
controller
Product Overview
Antec Controls Retrofit are designed to replace obsolete controls
on currently installed Venturi Valves. The VVR is built to mount
directly onto the existing valves. Retrofits are designed to tether
into an existing potentiometer feedback airflow system or airflow
sensing system depending on application.
Safety Precautions
• Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
• When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
• Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
• Before servicing or cleaning unit, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally.
• Protect flammable materials nearby when brazing, Use flame
and heat protection barriers where needed. Always have a fire
extinguisher ready.
The manufacturer assumes no responsibility for personal injury or
property damage resulting from improper handling, installation,
service or operation of the product.
2 | VVR– Manual | AntecControls.com
TM
Critical Space Controller
CAUTION
This mark indicates an important point for the proper
function of the Venturi Valve
may cause unit failure. Pay close attention to all caution
points throughout this manual.
For local area support, please
contact your local Antec Controls
Representative
For more information visit
www.AntecControls.com
VVR - MANUAL
Retrofit.
Improper setup
Advertisement
Table of Contents
