Lenovo ThinkSystem SR250 Messages And Codes Reference page 14

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPEM4024I The RAID controller detected one or more possible configuration
problem within the subsystem. Please check the event logs and if
events are targeted to the same disk then replace the drive. If
necessary, contact technical support for additional assistance.([arg1],
[arg2],[arg3],[arg4],[arg5])
FQXSPEM4025I One or more virtual drive have problem. Please contact technical
support to resolve this issue.([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4026I Drive error was detected by RAID controller. Please contact technical
support to resolve this issue.([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4027I Drive error was detected by RAID controller. Please check the event
logs and if events are targeted to the same disk then replace the drive.
If necessary, contact technical support for additional assistance.
([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4028I The port [arg1] of PCIe device [arg2] at [arg3] has link [arg4].
FQXSPEM4029I All PCIe slots on [arg1] may not be functional based upon your current
CPU population.
FQXSPEM4030I A scheduled operation on the RAID controller has encountered an
issue. Refer to RAID Logs under Server Management, Local Storage,
for details.([arg1],[arg2],[arg3],[arg4],[arg5])
The bare metal connection process has been started.
FQXSPFC4000I
FQXSPFC4001I The bare metal update application reports a status of [arg1].
FQXSPFC4002I System running in setup.
FQXSPFC4003I UEFI deployment boot mode is enabled for NextBoot.
FQXSPFC4004I UEFI deployment boot mode is enabled for NextAc.
FQXSPFC4005I UEFI deployment boot mode has been disabled.
FQXSPFW0003I The System [ComputerSystemElementName] encountered firmware
progress.
FQXSPFW2000I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
FQXSPFW2001I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
FQXSPFW2002I The System [ComputerSystemElementName] has recovered from a
firmware hang.
FQXSPIO0000I The connector [PhysicalConnectorElementName] has been
connected.
FQXSPIO0010I A Correctable Bus Error has occurred on bus [SensorElementName].
FQXSPIO2001I The connector [PhysicalConnectorElementName] configuration error
has been repaired.
FQXSPIO2002I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
FQXSPIO2003I System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
10
ThinkSystem SR250 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational