Lenovo ThinkSystem SR250 Messages And Codes Reference page 155

Severity: Error
User Action:
1. Restart BMC via BMC setting under uEFI setup on LXPM left panel.
2. Perform AC reset if the error still exist.
Note: When performing AC reset, after power off AC, wait several seconds before power on AC.
After AC power is restored, power on the host system.
3. If the error still occurs, contact service to support.
• FQXPMEM0007M: Diagnostic image cannot be launched as "Console Redirection" is enabled
Severity: Error
User Action:
1. Disable "Configure Console Redirection" in UEFI Setup.
2. Perform AC reset if the error still exist.
Note: When performing AC reset, after power off AC, wait several seconds before power on AC.
After AC power is restored, power on the host system.
3. If the error still occurs, contact service to support.
• FQXPMEM0008M: Diagnostic image cannot be launched as the image may be corrupt
Severity: Error
User Action:
1. Update LXPM image to the latest level via BMC webUI
2. If the error still occurs, contact service to support.
• FQXPMEM0009M: Unexpected error occur
Severity: Error
User Action:
1. Restart BMC via BMC setting under uEFI setup on LXPM left panel.
2. Perform AC reset if the error still exist.
Note: When performing AC reset, after power off AC, wait several seconds before power on AC.
After AC power is restored, power on the host system.
3. If the error still occurs, contact service to support.
• FQXPMNM0001G: Failed to set new BMC network parameters.
Severity: Warning
User Action:
1. Ensure input parameters are correct.
2. Wait one minute and retry the setting.
3. Restart BMC via BMC setting under uEFI setup on LXPM left panel.
4. Retry the setting.
5. Use UEFI setup to set parameters (optional).
• FQXPMNM0002I: Set BMC network parameters to new values.
.
Chapter 4 XClarity Provisioning Manager events
151