Lenovo ThinkSystem SR250 V2 Quick Start Manual

ThinkSystem SR250 V2
Type 7D7Q and 7D7R
Quick Start

Your shipping box contains the following items:

SR250 V2
⚫
Material box, including printed documentation
⚫
If any item is missing or damaged, contact your place of purchase.
Ensure that you retain your proof of purchase and packing material.
They might be required to receive warranty service.

First glance

Server front view:

•
Four 3.5-inch drives model
VGA connector (optional)
USB 2.0 connector
USB 3.2 Gen 1 connector
•
Ten 2.5-inch hot-swap drives model
USB 2.0 connector
USB 3.2 Gen 1 connector
Front operator panel
Front operator panel
Four 3.5-inch drive bays
(0-3)
Rack release latches
VGA connector (optional)
Ten 2.5-inch hot-swap drive
bays (0-9)
Rack release latches

Server rear view:

•
Fixed power supply model
PCIe slot 1
PCIe slot 2
Power connector
USB 3.2 Gen 2 connectors
Ethernet connector 2
Note 1: For the rear view of the redundant power supply model, there
are two power connectors on your server.
Note 2: Depending on the configuration, the illustrations above might
differ slightly from your server.

Setting up the System

1. Install the required server components.
2. Install the server into the rack.
See the Rack Installation Guide provided with the rail kit.
3. Connect the cables.
4. Connect the management controller to the network.
5. Power on the server.
6. Configure the system.
For detailed information about installing hardware options and
configuring the system, see the following website:
http://thinksystem.lenovofiles.com/help/topic/sr250-
v2/introduction.html
Ethernet connector 1
(shared with XCC network
port)
Dedicated XClarity
Controller (XCC) network
connector
VGA connector
Serial connector