Qos Port Shaping - ADTRAN SmartRG SR555ac User Manual

Field Name
Ether Type
Source MAC Address / Mask
Destination MAC Address / Mask
Source IP Address [/ Mask] or Vendor
Class ID or User Class ID
Destination IP Address
[/ Mask]
Differentiated Service Code Point
(DCP) Check
Protocol
UDP/TCP Source Port
UDP/TCP Destination Port
Specify Classification Results
Specify Egress Interface
Specify Egress Queue
Mark Applied Differentiated Service
Code Point
Set Rate Limit

QoS Port Shaping

On this page, you can configure a fixed rate (Kbps) for each of the Ethernet ports.
1. In the left navigation bar, click
appears.
SmartRG Inc., an ADTRAN Company Proprietary and Confidential. All Right Reserved. © 2020
Description
Select the Ethernet interface type for this classification. Options include IP, ARP, IPV6,
PPPoE, and any other Ethernet interface defined for your network.
(Available for LAN, ATM, ETH, PPP-Routed and wireless interfaces only) Enter the source
MAC address and source MAC mask for this classification.
(Available for LAN, ETH and wireless interfaces only) Enter the destination MAC address and
destination MAC mask for this classification.
(Available for WAN, ATM and PPP-Routed interfaces only) Select the source for this
classification. Options are:
Source IP
l
Vendor Class ID (DHCP Option
l
User Class ID (DHCP Option
l
(Available for WAN and ATM interfaces only) Enter the destination IP address and source IP
mask for this classification.
(Available for WAN, Local, ATM, and PPP-Routed interfaces only) Select the DSCP check
protocol. Options include default and a range of protocol IDs.
(Available for WAN, Local, and ATM interfaces only)Select the protocol specified for this
classification. Options are TCP, UDP, ICMP, and IGMP.
(Appears when TCP or UDP is selected in the
used for this classification. You can enter a range (port:port) or a single port.
(Appears when TCP or UDP is selected in the
be used for this classification. You can enter a range (port:port) or a single port.
section
Select an interface for outgoing traffic. Options include any interface defined for your
network.
Select from the available queues.
Note: Make sure to select a queue that is defined for the interface that you selected. If you
select a queue that is not defined for the selected interface, any packets classified into that
queue are processed by the default queue for the interface.
Select the desired DSCP code.
Enter the data traffic rate limit for this classification in kilobits per second.
Advanced Setup
Address[/Mask]: Enter the source IP address and source IP mask.
60): Enter the vendor class ID.
77): Enter the user class ID.
Protocol
Protocol
> Quality Of Service > QoS Port
field) Enter the source port to be
field) Enter the destination port to
Shaping. The following page
78