ADTRAN SmartRG SR555ac User Manual page 74

2. To add a queue:
a. Click
b. Fill in the fields, using the information in the following table. The visible fields vary by interface and
c. Click Apply/Save. You are returned to the Qos Queue Setup page.
3. To remove a queue, click the
bottom of the page.
4. Click Apply/Save
The applicable fields are explained below.
Field Name Description
Name Enter a descriptive name for this configuration.
Enable Select to enable or disable this QoS queue for the interface that you select. Options are Enable and Disable.
The default is Enable.
Interface Select the Layer 2 interface to be associated with the defined QoS queue, e.g., eth0 or ptm01.
Precedence (Appears when atm, eth or ptm interfaces are selected in the
be associated with the defined QoS queue. Options vary by interface and can include 1(SP), 2(SP), 3(WRR), 4
(SP|WRR|WFQ), and so on.
Note: The lower the precedence value, the higher priority the queue is given. Traffic is given priority based
on the combined values from this field and
The following fields become visible based on your selections in the
your selections. The fields are listed below in alphabetical order.
DSL Latency This option is set to Path0 by default and cannot be changed. No error correction is performed. This can
reduce latency on error-free lines.
SmartRG Inc., an ADTRAN Company Proprietary and Confidential. All Right Reserved. © 2020
Add at the bottom of the table. The following page appears.
queue precedence selections. In most cases, you can use the default values.
Remove checkbox to the right of the entry and then click the
to save your settings.
Interface
Queue Weight field.
Interface and Precedence
Remove button at the
fields) Select the priority value to
fields. Which fields appear vary by
74