Heater Engine Installation; Masonry Installation - Rinnai RIB2312L Operation & Installation Manual

Sapphire gas log flame fire

Hide thumbs Also See for RIB2312L:

Installation manual (36 pages)

Installation manual (36 pages)

Table of Contents

MASONRY INSTALLATION

Read this manual thoroughly and gain a full understanding of the requirements before

undertaking installation.

IMPORTANT

Ensure gas supply to heater is turned off for the first stages of this instruction.

Step 1.

Prepare Site - p.28

Step 2.

Unpack The Heater Engine - p.28

Step 3.

Preparing Heater Engine - p.28

Step 4.

Positioning the Heater Engine - p.29

Step 5.

Connect Electrical Supply - p.29

Step 1. Prepare Site

Ensure the intended enclosure meets the requirements of the dimensions as stipulated in

"ENCLOSURE REQUIREMENTS" on page 22 and that gas and electrical supplies have been

IMPORTANT

prepared in accordance with the dimensions stipulated in "GAS SUPPLY" on page 23 and

"ELECTRICAL SUPPLY" on page 24.

Step 2. Unpack The Heater Engine

The heater engine is supplied in one carton, check to ensure you have all contents as listed on "BEFORE YOU

START" on page 4 at the start of this manual before proceeding.

Carefully remove carton by removing the straps and lifting the carton off the appliance. Remove all packaging

materials and check all components for damage. If ANY damage is evident DO NOT install or operate this

appliance. Contact your supplier for advice.

Retain the cardboard carton for use in the "Positioning the Heater Engine" on page 29.

HINT

Before installing the heater, check it is labelled for the correct gas type, (refer to the gas type label on the top body

panel of the heater). Refer to the local gas authority for confirmation of gas type if you are in doubt.

Step 3. Preparing Heater Engine

Attach the adhesive backed foam sealing

strip

supplied to rear face of the fascia

assembly mounting panel

seal is stuck to the Fascia Assembly

mounting panel at approximately 30mm from

the top edge

The foam strip is intended to form a seal

between the heater and the fireplace

brickwork. If an adequate seal cannot be

formed then another means of sealing must

then

used.

(e.g.

insulation or heat resistant silicon).

Rinnai