Restore - DEEP SEA ELECTRONICS DSEControl DSEM812 Installation And Operator's Manual

4.4.3.5

RESTORE

NOTE: Restore is applicable to DSEM812 CODESYS variant only.
NOTE: If configured, the device Password is required to access this section.
NOTE: Recovering a file to the device overwrites the existing application. Depending
upon the type of clone file, Persistent/Retained data may also be overwritten.
This section is used to restore the device from a previously stored Clone (backup) file.
Parameter
Operation
Description
If the USB device is not connected or not detected, a red USB
icon is shown.
Connect USB memory stick containing the Clone file and
select the file to Restore from.
NOTE: Recovering a file to the device overwrites the
existing application. Depending upon the type of clone
file, Persistent/Retained data may also be overwritten.
A green USB icon shows that the USB device is detected.
Navigate the file system to select the file to Restore from.
usbhd-sda1: The name of DSEM812 USB port. Press it to
select the USB device and view the contents.
If required, select a subdirectory. Press .. (two dots) to go
back up one subdirectory level.
Select the required file. Check carefully the file name when
asked to confirm. Press YES to confirm and install this file or
NO to cancel the process and select again.
Circle animation is displayed during the process.
Press to return to the Device Control menu.
Page 45 of 50 057-317 ISSUE: 1.1