Dodge Neon 2001 Service Manual page 32

AIRBAG
ACM, DRIVER SQUIB CIRCUIT OPEN - ACTIVE —
TEST
4 NOTE: Ensure that the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Clockspring connector.
Disconnect the Airbag Control Module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the Airbag System Load Tool 8310 ACM Adaptor to the Airbag Control
Module connector.
Measure the resistance of the Driver Airbag Line 2 circuit between the ACM Adaptor
and the Clockspring connector.
Is the resistance below 5.0 ohms?
Yes → Go To 5
→ Repair the Driver Airbag Line 2 circuit for an open or high
No
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
5 NOTE: Ensure that the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE AIRBAG MODULE IS DROPPED AT ANY TIME, IT MUST
BE REPLACED.
If there are no possible causes remaining, view repair.
Repair
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
ACTION
resistance.
Perform AIRBAG VERIFICATION TEST - VER 1.
Replace the Airbag Control Module in accordance with Service
Instructions. WARNING: make sure the battery is disconnected
and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
24
Continued
APPLICABILITY
All
All