Vtss Fails To Arm/Disarm From Driver Door Cylinder Lock; Switch - Dodge Neon 2001 Service Manual

Symptom:
*VTSS FAILS TO ARM/DISARM FROM DRIVER DOOR CYLINDER
LOCK SWITCH
DOOR LOCK OPERATION TEST
GROUND CIRCUIT OPEN
LEFT FRONT DOOR SWITCH MUX CIRCUIT OPEN
DRIVER CYLINDER LOCK SWITCH FAULTY
TEST
1 Open the driver door and operate the door locks from the door lock switch.
Did the door locks operate properly?
Yes → Go To 2
→ Refer to symptom: *ALL LOCKS INOPERATIVE FROM DRIVER
No
2 Disconnect the Cylinder Lock Switch connector.
Measure the resistance of the ground circuit to body ground.
Is the resistance below 5.0 ohms?
Yes → Go To 3
→ Repair the ground circuit for an open.
No
3 Disconnect the Cylinder Lock Switch connector.
Measure the voltage between the Driver Door Switch Mux circuit and ground.
Is the voltage approximately 5.0 volts?
Yes → Replace the Driver Cylinder Lock Switch.
→ Repair the Left Front Door Switch Mux circuit for an open.
No
POSSIBLE CAUSES
ACTION
DOOR LOCK SWITCH in the POWER DOOR LOCKS/RKE
category.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
VEHICLE THEFT/SECURITY
203
APPLICABILITY
All
All
All