Vtss Indicator Stays On Steady During Arming - Dodge Neon 2001 Service Manual

VEHICLE THEFT/SECURITY
Symptom:

*VTSS INDICATOR STAYS ON STEADY DURING ARMING

DECKLID SECURITY SWITCH GROUND CIRCUIT OPEN
REMOTE KEYLESS ENTRY MODULE
REMOTE KEYLESS ENTRY MODULE
DECKLID SECURITY SWITCH SENSE CIRCUIT OPEN
DECKLID SECURITY SWITCH
HOOD AJAR SWITCH SENSE CIRCUIT SHORTED TO GROUND
HOOD AJAR SWITCH
TEST
1 Ensure the hood is closed and aligned properly.
With the DRBIII , read the Hood Ajar status.
Does the DRBIII show OPEN?
Yes → Go To 2
→ Go To 6
No
2 With the DRBIII , read the VTSS Decklid Security Switch state.
Does the DRBIII show PRESENT?
Yes → Replace the Remote Keyless Entry Module.
→ Go To 3
No
3 Disconnect the Remote Keyless Entry Module connector.
Measure the resistance of the Decklid Security Switch Sense circuit to ground.
Is the resistance below 10.0 ohms?
Yes → Replace the Remote Keyless Entry Module.
→ Go To 4
No
4 Disconnect the Decklid Security Switch connector (behind decklid lock cylinder).
Using a 12-volt Test Light connected to 12-volts, test the Ground circuit for
continuity.
Does the light illuminate?
Yes → Go To 5
→ Repair the Decklid Security Switch Ground circuit for an open.
No
POSSIBLE CAUSES
ACTION
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
206
APPLICABILITY
All
All
All
All