INTERIOR LIGHTING
*COURTESY LAMPS ON AT ALL TIMES —
TEST
8
Remove all 3 passenger door ajar switches.
With the DRBIII ,select: Body,Electro/Mech Cluster,Input/Output.
Read the Pas Door Ajar Sw-state.
Disconnect the RKE Module connector while observing the DRBIII .
Did the DRBIII show, Pas Door Ajar Sw: Open?
Yes → Replace the Remote Keyless Entry Module.
→ Go To 9
No
9
Turn the ignition off.
Disconnect all 3 passenger door ajar switches.
Disconnect the RKE Module connector - If Equipped.
Disconnect the Instrument Cluster connector.
Measure the resistance of the Passenger Door Ajar Circuit in the Passenger Door
Ajar Switch connector.
Is the resistance below 100.0 ohms?
Yes → Repair the Passenger Door Ajar/RKE Sense Wire for a short to
→ Replace the Instrument Cluster.
No
10
Turn the Panel Lamps Dimmer to the MID position.
Disconnect the Instrument Cluster Connector.
Measure the resistance between ground and the Courtesy Lamp Driver Circuit.
Is the resistance below 100.0 ohms?
Yes → Repair the Courtesy Lamp Driver Circuit for a short to ground.
→ Replace the Instrument Cluster.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
168
APPLICABILITY
All
All
All