Dodge Neon 2001 Service Manual page 180

POWER DOOR LOCKS/RKE
*ALL DOOR LOCKS INOPERATIVE —
TEST
8 Disconnect the Remote Keyless Entry module connector.
Measure the resistance of the Door Lock Relay Output circuit in the RKE module
connector to ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the Door Lock Relay Output wire for a short to ground.
→ Go To 9
No
9 Turn ignition off.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance of the Door Unlock Relay Output circuit in the RKE module
connector to ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the Door Unlock Relay Output wire for a short to ground.
→ Test Complete.
No
10 Disconnect the RKE Module connector.
Using a test light, test both sides of Fuse #14 to ensure the fuse is Okay and that the
12.0 volt supply is not open.
Measure the Voltage of the Fused B(+) circuit (cavity #3) in the RKE Module
connector.
Is the voltage above 10.0 volts?
Yes → Go To 11
→ Repair the open Fused B(+) wire from the RKE Module connector
No
11 Turn ignition off.
Disconnect the RKE Module connector.
Measure the resistance of the ground circuit (cavity #8) in the RKE Module
connector.
Is the resistance below 5.0 ohms?
Yes → Go To 12
→ Repair the open ground circuit.
No
12 Disconnect the Remote Keyless Entry module connector.
Measure the resistance between the Driver Door Unlock Relay Output circuit and the
Door Lock Relay Output circuit in the RKE module connector..
Is the resistance LESS than 17.0 ohms?
Yes → Go To 13
→ Repair the open Door Lock Relay Output circuit.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
to the fuse.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
172
APPLICABILITY
All
All
All
All
All