Dodge Neon 2001 Service Manual page 179

*ALL DOOR LOCKS INOPERATIVE —
TEST
3 Turn ignition off.
Remove Fuse #14 in the Fuse Block.
Disconnect the RKE Module connector.
Measure the resistance of the fused B(+) circuit (cavity #3) in the RKE connector to
ground.
Is the resistance below 100.0 ohms?
Yes → Repair fused B(+) wire for a short to ground and replace blown
→ Replace the Remote Keyless Entry Module.
No
4 Replace fuse #14.
Operate all the door locks including the decklid release (if equipped).
Did the system operate properly without blowing the fuse?
Yes → Test complete. If Fuse #14 blows again, check with the customer
→ Go To 5
No
5 Disconnect the Remote Keyless Entry module connector.
Measure the resistance of the Decklid Release Relay Output circuit to ground.
Is the resistance below 0.5 ohms?
Yes → Go To 6
→ Go To 7
No
6 Disconnect the Remote Keyless Entry module connector.
Disconnect the Decklid Solenoid connector.
Measure the resistance of the Decklid Release Relay Output circuit to ground.
Is the resistance below 100.0 ohms?
Yes → Repair the Decklid Release Relay Output wire for a short to
→ Replace the Decklid Release Solenoid.
No
7 Turn ignition off.
Disconnect the Remote Keyless Entry module connector.
Measure the resistance of the Driver Door Unlock Relay Output circuit in the RKE
module connector to ground.
Is the resistance below 1000.0 ohms?
Yes → Repair the Driver Door Unlock Relay Output wire for a short to
→ Go To 8
No
ACTION
fuse.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
as to when it blew and rerun this test.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
Continued
171
APPLICABILITY
All
All
All
All
All