Vtss Indicator Fails To Flash - Dodge Neon 2001 Service Manual

Symptom:

*VTSS INDICATOR FAILS TO FLASH

REMOTE KEYLESS ENTRY MODULE
INSTRUMENT CLUSTER
VTSS INDICATOR DRIVER CIRCUIT OPEN
VTSS LED OPEN
TEST
1 NOTE: The VTSS must be enabled for the Indicator Lamp to operate. To help
ensure an accurate diagnosis, verify the system is enabled before proceed-
ing.
Disconnect the Remote Keyless Entry Module connector.
Connect a jumper wire between the VTSS Indicator Driver circuit and ground.
Does the VTSS Indicator illuminate?
Yes → Replace the Remote Keyless Entry Module.
→ Go To 2
No
2 Disconnect the Remote Keyless Entry Module connector.
Disconnect the Instrument Cluster connector.
Measure the resistance of the VTSS Indicator Driver circuit between the RKE
module connector and the Instrument Cluster connector.
Is the resistance below 5.0 ohms?
Yes → Go To 3
→ Repair the VTSS Indicator Driver circuit for an open.
No
3 Remove the VTSS Indicator LED from the Instrument Cluster.
Test the VTSS Indicator LED for functionality.
Does the VTSS Indicator LED light?
Yes → Replace the Instrument Cluster.
→ Replace the VTSS LED.
No
POSSIBLE CAUSES
ACTION
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
Perform VTSS VERIFICATION TEST - 1A.
VEHICLE THEFT/SECURITY
205
APPLICABILITY
All
All
All