Dodge Neon 2001 Service Manual page 106

AUDIO
LEFT OUTPUT SHORT —
TEST
3 Turn the ignition off.
Disconnect the Left I/P Speaker harness connector.
Turn the ignition on.
Turn the radio on.
With the DRBIII , erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII , read DTC's.
Does the DRBIII display LEFT OUTPUT SHORT?
Yes → Go To 4
→ Replace the Left I/P Speaker.
No
4 Turn the ignition off.
Disconnect the Left Rear Speaker harness connector.
Turn the ignition on.
Turn the radio on.
With the DRBIII , erase the audio DTCs.
Cycle the ignition switch from off to on and wait 10 seconds.
With the DRBIII , read DTC's.
Does the DRBIII display LEFT OUTPUT SHORT?
Yes → Go To 5
→ Replace the Left Rear Speaker.
No
5 Turn the ignition off.
Disconnect the Left Front Door Speaker harness connector.
Disconnect the Left I/P Speaker harness connector.
Disconnect the Left Rear Speaker harness connector.
Disconnect the Radio C1 harness connector.
Measure the resistance between ground and each left speaker (+) circuit.
Is the resistance below 1000.0 (1K) ohms?
Yes → Repair the left speaker (+) circuit for a short to ground.
→ Go To 6
No
6 Turn the ignition off.
Disconnect the Left Front Door Speaker harness connector.
Disconnect the Left I/P Speaker harness connector.
Disconnect the Left Rear Speaker harness connector.
Disconnect the Radio C1 and C2 harness connector.
Measure the resistance between ground and each left speaker (-) circuit.
Is the resistance below 1000.0 (1K) ohms?
Yes → Repair the left speaker (-) circuit for a short to ground.
→ Go To 7
No
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
98
APPLICABILITY
All
All
All
All