Symptom:
*HIGH BEAM HEADLAMPS WILL NOT TURN OFF
DIMMER SWITCH HIGH BEAM OUTPUT CIRCUIT SHORT TO VOLTAGE
INSTRUMENT CLUSTER
MULTIFUNCTION SWITCH
TEST
1
Remove Circuit Breaker 2 from the Fuse Block.
Do the High Beam Headlamps turn off?
Yes → Go To 2
→ Repair the Dimmer Switch High Beam Output Circuit for a short
No
2
Disconnect the Instrument Cluster connector.
Disconnect the Multifunction Switch connector.
Measure resistance of the Dimmer Switch High Beam Output Circuit to ground.
Is the resistance below 5.0 ohms?
Yes → Replace the Instrument Cluster.
→ Replace the Multifunction Switch.
No
POSSIBLE CAUSES
ACTION
to voltage condition.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
EXTERIOR LIGHTING
135
APPLICABILITY
All
All