Acm, Driver Squib Short To Battery - Active - Dodge Neon 2001 Service Manual

Hide thumbs Also See for Neon 2001:
Table of Contents

Advertisement

AIRBAG
Symptom:

ACM, DRIVER SQUIB SHORT TO BATTERY - ACTIVE

When Monitored and Set Condition:
ACM, DRIVER SQUIB SHORT TO BATTERY - ACTIVE
When Monitored: When the ignition is on, the ACM monitors the voltage of the Driver
Squib circuits.
Set Condition: The code will set if the ACM detects any voltage on the Driver Squib
circuits.
DRIVER AIRBAG MODULE SHORT TO BATTERY
CLOCKSPRING, DRIVER AIRBAG SHORT TO BATTERY
DRIVER AIRBAG LINE 1 SHORT TO BATTERY
DRIVER AIRBAG LINE 2 SHORT TO BATTERY
ACM, DRIVER AIRBAG SHORT TO BATTERY
TEST
1
NOTE: Ensure the battery is fully charged.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERIOUS OR
FATAL INJURY.
Disconnect the Driver Airbag.
NOTE: Check connectors - Clean and repair as necessary.
Connect the Airbag System Load Tool 8310 brown cable and jumper harness to the
Driver Airbag connector.
Turn Ignition On and then reconnect the Battery.
With the DRBIII , read the active codes.
Does the DRB show DRIVER SQUIB SHORT TO BATTERY?
Yes → Go To 2
→ Replace the Driver Airbag Module.
No
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
POSSIBLE CAUSES
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
28
APPLICABILITY
All

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents