Table of Contents
Advertisement
#
Status
145 VOM Board
Signal Group (SST+SIGN?)
The Signal group provides values and fault conditions relating to the video signal status for Christie
TruLife+.
#
Status
50
Output Frequency
51
Frame Locked
Christie TruLife+ Technical Reference–Status System
020-103327-03 Rev. 1 (04-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
State
Value
Communication Fault
Programming
Detection Fault
Upgrade Failed
OK
Unknown
Communication Fault
Detection Fault
Initialize Fault
Communication Fault
State
Value
N/A
<rate>Hz
N/A
Locked
Christie TruLife+ status system
Description
Lost communication with the module
after the module has been detected.
Upgrading the photon software.
Cannot establish communication with the
photon module after system start up.
The upgrade failed.
Properly detected and initialized the
device.
Cannot determine the status of the
device.
The device failed to respond or provided
a bad response to a command while the
light source is on.
The projector remains on until the AC
power is removed even if this warning
condition is fixed.
Cannot read the device hardware
information.
Cannot properly initialize the device.
The device failed to respond or provided
a bad response to a command while the
projector is in Standby mode.
Description
No video is being displayed.
Where <rate> : the output frame rate,
in Hertz
No video is being displayed or an
internal test pattern is being
displayed.
The output is locked to the selected
input(s).
10
Advertisement
Table of Contents
