Christie TruLife+ Technical Reference page 15

# Status
117 Laser Standby Hours
118 Laser On Hours
119 Laser On Cycles
120 UCD MFG Calibration
121 LOS Dewpoint
122 Laser Boot SW Version
123 Laser Main SW Version
124 Laser UCD SW Version
125 Laser HKB FPGA Version
126 Laser HKB HW Version
127 Laser CSB HW Version
Christie TruLife+ Technical Reference–Status System
020-103327-03 Rev. 1 (04-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
State Value
<standby hours>
<laser on hours>
<count>
OK
Warning
OK
Approaching limit
Reached limit
<version>
<invalid version number>
<version>
<invalid version number>
<version>
<invalid version number>
<version>
<invalid version number>
<type>.<version>.<mod>
<invalid version number>
<type>.<version>.<mod>
Christie TruLife+ status system
Description
Displays the hours spent by the LOS in
Standby mode. These hours are not the
same as the projector standby hours.
Displays the laser on hours.
Displays the number of cycles the lasers
were turned on from off.
UCD calibrations are OK.
One or more UCDs are missing
calibration.
Displays the dew point inside the LOS.
User dew point (set using Max Ambient
Temperature) is approaching the LOS
dew point.
User dew point (set using Max Ambient
Temperature) has reached the LOS dew
point. Brightness may be reduced.
Version is OK.
A version mismatch exists.
Version is OK.
A version mismatch exists.
UCD version is OK.
At least one UCD version mismatch
exists (upgrade failed).
Housekeeping board (HKB) FPGA version
is OK.
A housekeeping board (HKB) FPGA
version mismatch exists.
Housekeeping board (HKB) hardware
version is OK.
A housekeeping board (HKB) hardware
version mismatch exists.
Color sensor board (CSB) hardware
version is OK.
15