Table of Contents
Advertisement
#
Status
12
Keypad Display
13
Power Supply
Christie TruLife+ Technical Reference–Status System
020-103327-03 Rev. 1 (04-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
State
Value
Detection Fault
Initialization Fault
Communication Fault
Auto Detect
Programming
OK
Detection Fault
Unexpected Behavior
Upgrade Failed
OK
Off
Unknown
Communication Fault
Failed
Overtemperature
Upgrade Failed
Failed
AC Input Failure
Christie TruLife+ status system
Description
The projector remains on until AC power
is removed, even if this warning
condition is fixed.
Cannot read the device hardware
information.
Cannot properly initialize the device.
The device failed to respond or it
provided a bad response to a command
while the projector is in standby mode.
The projector is attempting to detect the
presence of the keypad display device.
Programming the device with the correct
firmware.
Properly detected and initialized the
device.
Cannot detect the keypad display device.
The device is not responding correctly.
The device failed to upgrade properly.
Detected the power supply and the
output stage is on.
The power supply output stage is off.
Cannot determine the status of the
power supply due to an upstream
communication fault.
Cannot detect the power supply due to a
communication failure.
A non-catastrophic error occurred. See
the logs for more information.
The power supply reports a High-Temp
alarm but no fan failure is reported.
Failed to upgrade the power supply.
A fatal power supply error occurred. See
the logs for more information.
The power supply suffered from an input
failure.
7
Advertisement
Table of Contents
