Table of Contents
Advertisement
#
Status
5
Lens Motor Horizontal-Axis
6
Lens Motor Vertical-Axis
7
Lens Motor Zoom- Axis
8
Lens Motor Focus- Axis
9
Built-In Self Test
10
System ID Board
11
Housekeeping Board
Christie TruLife+ Technical Reference–Status System
020-103327-03 Rev. 1 (04-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
State
Value
Communication Fault
Calibrating
Calibrated
Unknown
Uncalibrated
Failed
N/A
Passed
Failed
OK
Unknown
Communication Fault
Invalid Data
OK
Unknown
Communication Fault
Christie TruLife+ status system
Description
• A negative pitch means that the
projector is pointing down.
• A negative roll means the projector
is tilted counter clockwise as seen
from the rear.
Information is not available due to a
hardware fault.
Currently calibrating the lens motor.
Properly calibrated the motor range.
The status of the motor is unknown
because a problem occurred in the
upstream communication path.
The range for the current lens has not
been determined and/or the reported
position on the axis may be inaccurate.
During reset or calibration, an error was
detected related to the motor and/or
sensor.
The built-in self test has not been
executed yet.
The built-in self test completed
successfully.
The built-in self-test failed.
Properly detected and initialized the
device.
Cannot determine the status of the
device.
Cannot communicate with the device.
The information on the device is missing
or corrupted.
Properly detected and initialized the
device.
Cannot determine the status of the
device.
The device failed to respond or provided
a bad response to a command while the
light source is on.
6
Advertisement
Table of Contents
