Software Overview; Function Keys (Main Menu) - Hartridge CRi-PC Operating And Servicing Manual

CRi-PC Operating and Servicing Manual
4.2

Software Overview

The test bench is controlled through Magmah software.
At power-up the Main Screen is displayed (refer to Figure 4.1). The screen is divided into
sections as described below. Further screens and dialogs are accessed via the function keys.
Click the relevant on-screen key.
Alternate menu
4.2.1

Function keys (Main Menu)

F1 Start Test:
Refer to Figure 4.7
Has to be pressed before any injections will take place. Pulls up a start test dialog which will
have non mandatory fields to fill in (operator name, serial numbers etc.). Also has drop down
boxes for Testplan selection and selection for automatic or semi-auto mode.
F2 –F3 Previous Step – Next Step:
In Manual Test mode these allow the user to step forward and back through test steps of a
previously loaded testplan (will be greyed out otherwise). No action on these steps will be
taken unless F4 – Apply Step is also pressed.
F4 Apply Step:
Will apply test step. (Will also need to be pressed if the pressure demand, injection speed etc
are changed manually)
72
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
Figure 4.1 Main Screen
HARTRIDGE LIMITED
HL037 (EN), Issue 13, AT714, 05/14